SIP D-Subminiature - Ordering Information
Overview
| Product
Specs | Ordering Info | Product
PDF | Buy
Now
ORDERING INFORMATION
To order a SIP, choose the connector type depicted
above that accommodates the system application to be protected.
NOTE:
Special units can be supplied for any voltage
between 7.5 V and 240 V. The following information must be specified when
ordering special units:
1. Connector type and pin assignment (ex., DB9
pins (1),2,3,4 & 7) ( ) = pin designated as chassis or earth ground
2. System application (ex., RS232)
INSTALLATION
To install, insert the protector in series between
the incoming communication lines and the I/O port of the equipment to
be protected. The protector ground wire must be connected to the metal
chassis of the equipment being protected. Units should be installed at
both ends of the data cable for the most effective protection.
CAUTION!
Ground wire must be grounded directly to the metal
chassis of the equipment being protected. The equipment chassis must be
connected to earth through a properly grounded AC power receptacle.
|
