RAK Rack Mount RJ11/RJ45 - Ordering Info

ORDERING INFORMATION

To order a RAK, choose the correct part number by selecting the system application the above chart.

NOTE:

Special units can be supplied for any clamp voltage between 7.5 V and 240 V. The following information must be specified when ordering special units: 1. Connector type and number of wires to be protected (ex., RJ45, 8 wires) 2. System application (ex., Token Ring, Ethernet, ISDN, T1)

INSTALLATION

To install, insert the protector in series between the incoming communication lines and the I/O port of the equipment to be protected. The protector ground wire must be connected to the metal chassis of the equipment being protected. Units should be installed at both ends of the data cable for effective protection.

CAUTION!

Ground wire must be grounded directly to the metal chassis of the equipment being protected. Also, the equipment chassis must be connected to earth through a properly grounded AC power receptacle.