CCP (Coax) - Ordering Information
Overview
| Product
Specs | Ordering Info | Product
PDF | Buy
Now
ORDERING INFORMATION
To order a CCP, choose the correct part number
by selecting the system application and connector type from the above
chart. See figures A through I for product physical outlines.
NOTE: Special units can be supplied for
any clamp voltage between 7.5 V and 240 V. The following information must
be specified when ordering special units: 1. Connector type and gender
(ex., BNC male/female) 2. System application/protocol (ex., Ethernet 10BASE
2)
INSTALLATION
To install, insert the protector in series between
the incoming communication lines and the I/O port of the equipment to
be protected. The protector ground wire must be connected to the metal
chassis of the equipment being protected. Units must be installed at both
ends of the data cable for effective protection.
CAUTION!
Ground wire must be grounded directly to the metal
chassis of the equipment being protected. The equipment chassis must be
connected to earth through a properly grounded AC power receptacle.
|
