TSP Hardwired - Ordering Information
Overview
| Product
Specs | Ordering Info | Product
PDF | Buy
Now
ORDERING INFORMATION
To order a TSP, choose the correct part number
by selecting the system application and connector type from the above
chart. See figures A, B and C for product physical outlines.
NOTE:
Special units can be supplied for any clamp voltage
between 7.5 V and 240 V. The following information must be specified when
ordering special units: 1. Connector type and number of wires (ex., barrier
strip, 4 wires) 2. System application ex., 4-20 mA current loop)
INSTALLATION
To install, insert the protector in series between
the incoming communication lines and the I/O port of the equipment to
be protected. The protector ground wire must be connected to the metal
chassis of the equipment being protected. Units should be installed at
both ends of the data cable for the most effective protection.
CAUTION!
If the protector has a ground wire it must be
grounded directly to the metal chassis of the equipment being protected.
Also, the equipment chassis must be connected to earth through a properly
grounded AC power receptacle.
CYLIX CIRCLE OF PROTECTION WARRANTY
The Cylix Corporation offers our "Circle of Protection"
Warranty which includes a $25,000 Connected Equipment Guarantee, 5 Year
Replacement Program and a Limited Lifetime Warranty. This warranty applies
only to serialized products registered with The Cylix Corporation and
is subject to certain disclaimers and limitations.
For a complete warranty statement, please contact
The Cylix Corporation. All specifications and dimensions are subject to
change without notice. The Cylix Corporation 4/00.
|
