PCH Rack Mount 110 Punchdown RJ45 - Ordering Information

ORDERING INFORMATION

To order a PCH, choose the correct part number by referring to the "Product Specifications" chart here.

INSTALLATION

Remove power to the unprotected equipment Mount the patch panel to your 19" relay rack using the supplied hardware Disconnect the incoming data lines from the equipment Attach the ground strap to your rack. The installer should confirm a proper rack to earth ground connection. Consult with an electrician if needed.

Try to keep the resistance from the supplied fork terminal ground to the rack frame minimal. It is imperative that both the PCH and the equipment to be protected are properly grounded for effective operation. Using a 110 punch down tool, install the cable "22-26 AWG wire" matching the color code on the 110 IDC (Insulation Displacement Contact) Maintain pair twist, up to point of termination, for maximum performance (untwist less than 0.5") Connect the patch panel to the equipment

NOTE

These protectors reset themselves after protecting equipment from surges. In the event that lightning or other extreme surge events have exceeded the maximum capability of the protector, these devices are designed to self-destruct in a "fail-safe" mode rather than allow damage to equipment. Installations often require a protector at each end of the data line (call our technical support group with any questions).

CYLIX CIRCLE OF PROTECTION WARRANTY

The Cylix Corporation offers our "Circle of Protection" Warranty which includes a $25,000 Connected Equipment Guarantee, 5 Year Replacement Program and a Limited Lifetime Warranty. This warranty applies only to serialized products registered with The Cylix Corporation and is subject to certain disclaimers and limitations. For a complete warranty statement, please contact The Cylix Corporation. All specifications and dimensions are subject to change without notice. Cylix Corporation 7/06